Putting customer’s interests first, offering sound, impartial technical advice on building and environmental issues, good product knowledge we can supply a cost effective range of thermal, acoustic and fire protection insulation products to the construction industry throughout the UK whilst meeting current regulations. Products from all major manufacturers covering thermal, acoustic and fire insulation requirements for walls, lofts, roofs, floors and civil engineering applications and including a full range of accessories.
With reduced water absorption properties that are required in inverted roofs, Modified expanded polystyrene is produced with increased performance and higher stability it is a cost effective easy to use insulation for inverted roofing.
Linear Acoustic Infill consists of trapezoidal shaped mineral wool factory cut to fit the profile of a roof decking in order to significantly improve the sound absorption. Available plain or can be faced on all four sides with glass tissue to improve aesthetic appearance and reduce the potential for fibre migration. 
Linear Fire stops are manufactured from non-combustible mineral wool and are designed to prevent the passage of fire at the point where masonry walls meet concrete soffits and profiled metal decking or as an expansion joint in masonry walls. 
Environmentally friendly, interlocking extruded polystyrene cement topped board creates a lightweight protected roof with a high compressive strength, good thermal and fire performance, resistance to wind uplift and is safe and easy to install. With reduced dead loading, suitable for intermittent traffic to protect the waterproofing. 
Phenolic has low flame spread, increased fire performance, negligible smoke and toxic gas emission, can be 50% more thermally efficient than other insulants, low thermal conductivity which allows for reduced insulation thicknesses. 
Hemp is environmentally sustainable, non toxic, non irritant responsible alternative to conventional insulation, offering comparable thermal and acoustic performance for use in loft spaces, between rafters and within walls and floors, but are unsuitable for cavity wall insulation, or under ground floor slabs. 
Expanded polystyrene is easy to handle and cut, rot proof, long term durability uniform thickness or cut to falls systems, square or tongued and grooved edge detail. Available in various grades including high density for us on balconies etc it has factory bonded facings for use with bitumen, single ply, mastic asphalt and liquid waterproofing. 
Consisting of two layers of air bubble polyethylene, wedge-welded 15mm wide, covered with a film of low emission aluminium on both sides that blocks up to 97% of the radiant heat transfer and prevents heat gain in summer and heat loss in winter. Alum-Tech is an ideal insulation for flat and pitch roofs. 
Glass mineral wool has excellent thermal properties is perfect for reducing noise pollution, will not support combustion even in direct with flames, can be compressed for easy transport, easy to use reverts to its original volume after months under compression and is one of the most environmentally friendly, stable and sustainable insulants available and is recyclable for use in walls, floors and roof spaces of buildings. 
Cut to falls schemes are designed to provide an effective method of providing an adequate slope for the removal of water and reduce ponding, whilst satisfying current thermal regulations structure are lighter and eliminate the weight and slow drying associated with sand and cement screeds, are quicker and easier and less costly to install. 
Fully compatible with most waterproofing systems, resistant to the passage of water vapour, easy to handle and install, can be fully or partially bonded or mechanically fixed. CFC/HCFC high performance rigid urethane insulation provides cost effective environmentally friendly insulation for bitumen, mastic asphalt, liquid waterproofing and single ply systems and is ideal for new build or refurbishment. 
Cellular glass is impermeable to water and water vapour, non combustible and will not burn or give off toxic fumes, has high compressive strength, is dimensionally stable, insect, vermin and acid resistant to attack by birds and vermin and environmentally friendly, will not support the growth of mould, fungi or micro-organisms. 
Environmentally friendly, recyclable, properties, is unaffected and resistant to moisture, high compressive strength, is lightweight and easy to handle, flame-retardant with good thermal properties that reduces energy costs. 